Part 12 Removal of the Magneto Generator Housing ...

Introduction ...

This page contains photos of the process of removing the magneto generator housing from a ROTAX 912ULS engine (built August 2006.



ROTAX 912ULS magneto generator housing

Image 1

There are five internally situated bolts ...

View Larger Image ...

ROTAX 912ULS magneto generator housing

Image 2

There are also two bolts on the outside (lower section) of the generator housing (one can be seen here already removed) and two bolts located by the starter motor mounting point. Once all of these have been undone the housing may be tapped gently off the crankcase using a rubber mallet if needs be ...

View Larger Image ...

ROTAX 912ULS magneto generator housing

Image 3

Here is the removed generator housing on the bench ...

View Larger Image ...


ROTAX 912ULS magneto generator housing

Image 5

Here is a view of the engine exposing the main freewheel gear and the sprag clutch / housing once the generator housing has been removed ...

View Larger Image ...