Part 35 Refitting the Starter Motor ...

Introduction ...

This page contains photos of the process of re-fitting the starter motor to a ROTAX 912ULS engine (built August 2006).



ROTAX 912ULS refitting the starter motor

Image 1

Start by fitting a new o-ring ...

View Larger Image ...

ROTAX 912ULS refitting the starter motor

Image 2

Having applied some GP grease to both the o-ring and the starter motor gear, relocate the starter motor in it's mounting position on the magneto generator housing ...

View Larger Image ...

ROTAX 912ULS refitting the starter motor

Image 3

Next refit the washers and nuts to the thru studs and torque accordingly. This action will pull starter motor "home" into the correct postion in relation to the magneto generator housing ...

View Larger Image ...

ROTAX 912ULS refitting the starter motor

Image 4

Slide the starter motor clamp (Clamp 76) into position and tighten accordingly ...

View Larger Image ...

ROTAX 912ULS refitting the starter motor

Image 5

Here are some images of the starter motor in position ...

View Larger Image ...

ROTAX 912ULS refitting the starter motor

Image 6

Note the position of the clamp ...

View Larger Image ...