Part 38 Re-Fitting The Lower Coolant Hoses ...

Introduction ...

This page contains photos of the process of re-fitting the lower coolant hoses to a ROTAX 912ULS engine (built August 2006).



ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 1

Here we can see the lower coolant hose elbows ...

View Larger Image ...


ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 3

Having ensured that the end of the coolant elbows are clean, start by refitting the coolant hose to cylinders 1 and 3. Cut the hose to length and refit the hose clamps. Based on a visual inspection these clips were deemed to be in good enough condition to refit without replacement ...

View Larger Image ...


ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 5

The coolant hose carries the flow of coolant from the water pump outlet to the under side of the cylinder head ..

View Larger Image ...

ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 6

Coolant hose attached to lower elbows ...

View Larger Image ...

ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 7

Now turn your attention to cylinders 2 and 4 ...

View Larger Image ...


ROTAX 912ULS Re-Fitting The Lower Coolant Hoses

Image 9

Cylinders 2 and 4 lower coolant hoses in place ...

View Larger Image ...